IBM TotalStorage SAN140M Installation And Service Manual page 132

Table 8 Event codes versus maintenance action (Continued)
Event
code Explanation
506 Fibre Channel port failure.
507 Loopback diagnostics port failure.
508 Fibre Channel port anomaly detected.
510 Optical transceiver hot-insertion initiated.
512 Optical transceiver nonfatal error.
513 Optical transceiver hot-removal completed.
514 Optical transceiver failure.
515 Optical digital diagnostics warning threshold exceeded.
516 Optical digital diagnostics alarm threshold exceeded.
523 FL_Port open request failed.
524 No AL_PA acquired.
525 FL_Port arbitration timeout.
581 Implicit incident.
582 Bit error threshold exceeded.
583 Loss of signal or loss of synchronization.
584 Not operational primitive sequence received.
585 Primitive sequence timeout.
586 Invalid primitive sequence received for current link state.
600 SBAR assembly hot-insertion initiated.
601 SBAR assembly recognized.
602 SBAR assembly anomaly detected.
603 SBAR assembly hot-removal completed.
604 SBAR assembly failure.
605 SBAR assembly revision not supported.
607 Director contains no operational SBAR assemblies.
100 SAN140M Installation and Service Manual
Action
Go to MAP 0500.
Go to MAP 0500.
No action required.
No action required.
Go to MAP 0500.
No action required.
Go to MAP 0500
Go to MAP 0500.
Go to MAP 0500.
No action required.
No action required.
No action required.
Go to MAP 0500.
Go to MAP 0500.
Go to MAP 0500.
Go to MAP 0500.
Go to MAP 0500.
Go to MAP 0500.
No action required.
No action required.
No action required.
No action required.
Go to MAP 0400.
Go to MAP 0400.
Go to MAP 0400.