Ordering The Lift Tool; World Trade Locations - IBM TotalStorage SAN140M Installation And Service Manual

Ordering the lift tool

World Trade locations

• Customer-supplied PC or UNIX-based platform with the server
and client Element Manager application installed.
• Simple network management protocol (SNMP). An SNMP agent
is implemented through the SAN management application that
allows administrators on SNMP management workstations to
access director management information using any standard
network management tool. Administrators can assign internet
protocol (IP) addresses and corresponding community names for
up to 12 SNMP workstations functioning as SNMP trap message
recipients. Refer to the SNMP Support Manual (620-000131).
• Command line interface (CLI). The CLI allows you to access
many SAN management functions while entering commands
during a telnet session with the director. The primary purpose of
the CLI is to automate management of a large number of directors
using scripts. The CLI is not an interactive interface; no checking
is done for pre-existing conditions and no prompts display to
guide users through tasks. Refer to the E/OS Command Line
Interface User Manual, 620-000134.
CAUTION
Important! The lift tool is required when you install or remove a
director.
The ordering procedures for the lift tool vary depending on your
location. You should direct questions about these procedures to your
regional specialist.
The following ordering procedures are for world trade locations:
• Order the lift tool by using the parts order system, like any other
part.
• Use the following part numbers when you order:
• Lift tool (PN 09P2481)
• 24-inch load plate (PN 11P4369)
Chapter 1: General information 19