Inactive Port Reasons And Actions - IBM TotalStorage SAN140M Installation And Service Manual

NO YES
↓
The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.
14
A port is set to an inactive state.
a. At the Event Log, examine the first two bytes of event data.
b. Byte 0 specifies the port reporting the problem. Byte 1 specifies
the inactive reason

Inactive port reasons and actions

Table 17
Byte 1 Inactive port reason
02 Feature key not enabled.
03 Switch speed conflict.
04 Optics speed conflict.
06 Port swap conflict.
15
A port is inactive because Flexport Technology is disabled. Install the
Flexport Technology PFE key to enable N_Port capability
Configure PFE key (optional)
on page 47). Exit MAP.
16
A port is inactive because the:
• Port cannot operate at the product (backplane) speed.
• Optical transceiver does not support the configured port speed.
Change the port speed to be compatible with the backplane or optical
transceiver speed.
a. For the product reporting the problem:
— EFCM Basic Edition - Select Ports and Basic Info from the
Configure menu at any view. The Basic Information View
displays.
— Element Manager - Select Ports from the Configure menu
at any view. The Configure Ports dialog box displays.
Chapter 3: Maintenance analysis procedures (MAPS)
(Table 17).
on page 70 and Install PFE keys (optional)
Action
Go to step 15.
Go to step 16.
Go to step 16.
Go to step 17.
(Task 15:
135