IBM TotalStorage SAN140M Installation And Service Manual page 239

1. Notify the customer that the director will be set offline. Ensure
that the system administrator quiesces Fibre Channel traffic
through the director and sets attached devices offline.
2. Set the director offline
page 190).
3. At the EFCM Basic Edition interface, select Switch from the
Maintenance menu at any view. The Switch View displays.
4. Click Reset Configuration. A dialog box with the message "Are you
sure that you want to reset the configuration?" displays.
5. Click OK to reset the configuration. The message "Your changes
have been successfully activated." appears.
6. The IP address resets to the default of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as the
default, the browser-to-director Internet connection is not
affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the same
as the default, the browser-to-director Internet connection
drops and the EFCM Basic Edition session is lost. Continue to
the next step.
7. To change the director IP address and restart the EFCM Basic
Edition interface, see
(optional) on page 51. To restart the EFCM Basic Edition interface
using the default IP address of 10.1.1.10:
a. At the browser, enter the default IP address of 10.1.1.10 as the
Internet URL. The Enter Network Password dialog box displays.
b. Type the default user name and password.
NOTE: The default user name is Administrator and the default
password is password. The user name and password are
case-sensitive.
c. Click OK. The EFCM Basic Edition interface opens and the
procedure is complete.
(Setting the director online or offline
Task 5: Configure director network information
Chapter 4: Repair information
on
207