Sbar Assembly Removal And Replacement - IBM TotalStorage SAN140M Installation And Service Manual

Figure 78
Replacement
242 SAN140M Installation and Service Manual

SBAR assembly removal and replacement

Location Description
1 SBAR assembly
6. Using the handles, pull the SBAR assembly out of the director
chassis. Support the assembly with one hand.
7. Place the SBAR assembly in an anti-static bag to provide ESD
protection.
To replace an SBAR assembly:
1. Remove the replacement SBAR assembly from its protective
anti-static bag.
2. Inspect the printed wiring assembly (PWA) side of the SBAR
assembly for bent or broken connector pins that may have been
damaged during shipping. If any pins are damaged, obtain a new
assembly.
3. Orient the SBAR assembly
the director chassis guide, then push the assembly toward the
backplane to engage the connector pins. Verify the assembly is
flush and even with the other SBAR assembly in the director.
4. Close both handles.
5. Disconnect the ESD wrist strap from the director chassis and your
wrist.
(Figure 78). Insert the assembly into