IBM TotalStorage SAN140M Installation And Service Manual page 202

170 SAN140M Installation and Service Manual
• Operating Speed - The operating speed of the port (Not
Established, 1 Gbps, 2 Gbps, or 10 Gbps (with XPM)).
• Fibre Channel Address - The logical port address (hexadecimal
format). Not applicable for E_Ports.
• Port WWN - The Fibre Channel WWN of the port.
• Attached Port WWN - The Fibre Channel WWN of the device
attached to the port.
• Block Configuration - A user-configured state for the port
(Blocked or Unblocked).
• 10 - 100 km Configuration - The user-configured state for
extended distance operation (On or Off).
• Rx BB_Credits Configured - The user-defined number of receive
BB_Credits allocated to the port.
• NPIV Login Limit Configured - With N_Port ID virtualization
(NPIV) enabled, the user-defined maximum number of virtual
addresses assigned to the physical port.
• Logged in IDs - The number of virtual addresses logged in to the
physical port.
• LIN Alerts Configuration - A user-specified state for the port (On
or Off).
• FAN Configuration - A user-configured state for FAN
configuration (Enabled or Disabled).
• Beaconing - User-specified for the port (On or Off). When
beaconing is enabled, a yellow triangle appears adjacent to the
status field.
• Link Incident - If no link incidents are recorded, None appears in
the status field. If a link incident is recorded, a summary appears
describing the incident, and a yellow triangle appears adjacent to
the status field.
• Operational State - The state of the port (Online, Offline,
Beaconing, Invalid Attachment, Link Incident, Link Reset, No Light,
Not Operational, Port Failure, Segmented E_Port, or Testing). A
yellow triangle appears adjacent to the status field if the port is in
a non-standard state that requires attention. A red and yellow
diamond appears adjacent to the status field if the port fails.