Scsi Backplane Removal And Replacement - IBM eServer xSeries x382 Hardware Maintenance Manual And Troubleshooting Manual

SCSI backplane removal and replacement

Complete the following steps to remove the front panel board.
10. Lift the SCSI backplane out of the server.
To replace the SCSI backplane, align the three keyhole-shaped slots with the three
cylindrical pins on the peripheral module; then, reverse the steps for removing the
SCSI backplane.
66
IBM eServer xSeries x382 Type 8834: Hardware Maintenance Manual and Troubleshooting Guide
1. "Safety information" on page 95 and "Installation guidelines" on page 43.
2. Turn off the server and all attached devices, see"Turning off the server" on
page 9.
3. Disconnect all external cables and power cords.
4. Remove the cover (see "Cover removal and replacement" on page 49).
5. Remove all hard disk drives from the drive bays.
6. Remove the screw securing the cable retainer on the fan bracket; then,
remove the cable retainer.
7. Disconnect all cables from the SCSI backplane.
8. Remove the three screws holding the SCSI backplane in place.
SCSI backplane
Guide pins (4)
9. Slide the SCSI backplane toward the front panel board about 0.6 cm (0.2 in.)
until it stops.
Thumb screws