Configure Security - IBM TotalStorage SAN140M Installation And Service Manual

Configure security

3. Click the Enable Call Home Event Notification check box. A check
mark appears to indicate call-home event notification is enabled.
NOTE: The enable function must be activated for each product through
the Element Manager application.
4. Click Send Test. A call-home test message is sent.
5. Click OK to close the dialog box.
6. Maximize the Element Manager application.
7. Select Enable Call Home Notification from the Maintenance menu at
any view. A check mark appears to indicate call-home event
notification is enabled.
This section describes optional product security features configured
through the SAN management or Element Manager applications. The
enhanced SANtegrity PFE keys (SANtegrity authentication and
SANtegrity binding) must be installed
page 47). Features include:
• SANtegrity authentication - Select SANtegrity Authentication
from the Configure menu at the Element Manager application. The
SANtegrity Authentication dialog box provides five pages (tabs) to
configure optional authentication features, including:
— Users - Configure password-protected administrator and
operator access to the SAN management and Element
Manager applications.
— Software - Configure CHAP-controlled management interface
access (out-of-band and inband) to the product.
— Devices - Configure a CHAP secret authentication sequence
for nodes (devices) attached to the product through E_Ports or
N_ports.
— IP Access Control - Configure a list of device IP addresses or a
range of device IP addresses authorized to communicate with
the product.
— RADIUS Servers - Configure RADIUS servers. A RADIUS
server stores and authenticates passwords and CHAP secrets.
(Install PFE keys (optional)
Chapter 2: Installation tasks
on
87