Bushing Service - Polaris xp 2013 eps Service Manual

13. Inspect the bearing for wear. Spin the bearing, if the
bearing does not spin smoothly, replace it. To replace
the bearing, remove the snap ring from the end of the
shaft and press the bearing off the shaft.
14. Inspect the cam (helix) assembly bushing for wear. If
the bushing is worn or the shaft does not fit snug into
the bushing, replace the cam (helix) assembly.
Inspect Bushing
15. Inspect the sheaves for excessive wear or damage.
Inspect Sheave Surface
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
CLUTCHING (PVT)

Bushing Service

IMPORTANT: Special Tools Required
EBS Clutch Bushing Tool Kit - 2201379
Item Qty. Part #
A, B 1 5132027
C 1 5132501
D 1 5132029
E 1 5132028
-- 1 9915111
Additional Special Tools
Qty. Part #
Clutch Bushing Replacement Tool
1 2871226
1 2870386
*Clutch Bushing Replacement Tool Kit (PN 2871226)
#2
#8
Item Qty. Part #
#2 1 5020628
#3 1 5020629
#5 1 5020631
#8 1 5020632 Main Puller Adapter
#9 1 5010279 Adapter Reducer
#10 1 5020633
NOTE: Bushings are installed at the factory using
Loctite™ 609. In order to remove bushings it will be
necessary to apply heat evenly to the area around
each bushing. Clean all residual Loctite™ from
bushing bore prior to installing new bushing.
Tool Description
EBS Puller Tool
EBS Puller Nut
EBS Main Adapter
EBS Bushing Removal
Instructions
Tool Description
Piston Pin Puller
#3
#5
#9
#10
Tool Description
P-90 Drive/Driven Clutch
Bushing Install Tool
Drive Clutch Cover
Bushing Removal/
Installation Tool
(all clutches)
P-90 Driven Clutch Cover
Bushing Removal Tool
Number Two Puller
Adapter
6.23
6