Polaris xp 2013 eps Service Manual page 339

8. Loosely install the (2) longer bolts into left side
mounting holes and (2) shorter bolts with washers into
right side mounting holes.
IMPORTANT: DO NOT torque fasteners at this time.
9. Torque left side mounting bolts to specification in
sequence.
2
10. Torque right side mounting bolts to specification using
the numbered sequence shown.
6
3, 7
Engine / Transmission Mounting Bolts:
Step 1-2: 64 ft-lbs (87 Nm)
Step 3: 5 ft-lbs (7 Nm)
Step 4-7: 44 ft-lbs (60 Nm)
11. Remove the clutch center distance tool.
1
5
4
= T
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
12. Remove the spacer or support between the vehicle
frame and engine.
Remove Spacer / Support
13. Install and properly route the gear position switch
connector (A), speed
crankshaft position sensor connector (C), shift
bracket and shift bracket bolts (D), shift cable clevis
pin and washer (E) onto the transmission.
B
E
14. Torque the (2) shift cable bracket bolts to
specification.
Shift Cable Bracket Bolts:
17 ft-lbs (23 Nm)
TRANSMISSION
sensor connector (B),
C
A
D
= T
8.9
8