Battery Conductance Analyzer; Charging Procedure - Polaris xp 2013 eps Service Manual

ELECTRICAL

Battery Conductance Analyzer

Conductance describes the ability of a battery to conduct
current. A conductance tester functions by sending a low
frequency AC signal through the battery and a portion of
the current response is captured, from this output a
conductance measurement is calculated. Conductance
testing is more accurate than voltage, specific gravity, or
load testing.
Authorized Polaris dealers/distributors are required to use
the conductance analyzer when testing 12V Polaris
batteries.
Polaris MDX-610P
SPX PN: PU-50296
10.34
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.

Charging Procedure

If battery voltage is 12.6 Vdc or less, the battery may need
recharging. When using an automatic charger, refer to the
charger manufacturer's instructions for recharging.
Do not exceed 6 amps when charging the 4011224
battery.
NOTE: Charge the battery using an automatic
charger that will not exceed 14.6 Vdc. An automatic
charger will signal when charging is complete.
NOTE: Allow the battery to stand disconnected for
at least 1-2 hours after being properly charged. If the
voltage drops below 12.6 volts, charging was
ineffective or the battery needs to be replaced.
WARNING
An overheated battery could explode, causing severe
injury or death. Always watch charging times carefully.
Stop charging if the battery becomes very warm to the
touch. Allow it to cool before resuming charging.
State of
Voltage (DC)
Charge
100% 12.8 or more
75% - 100% 12.6 - 12.8
50% - 75% 12.3 - 12.6
25% - 50% 12.0 - 12.3
0% - 25% 12.0 or less Needs Charge
NOTE: Follow the charger instructions supplied by
the manufacture regarding the order or connections,
switch positions and when to connect the charger to
an outlet.
Charge
Action
Time
None, check
None
again in 3
Required
months
May need
3 - 6 hrs
slight charge
Needs Charge 5 - 11 hrs
At least
Needs Charge
13 hrs
At least
20 hrs