Polaris xp 2013 eps Service Manual page 307

3. Using a suitable arbor, fully seat the bearing cap in
one side. Continually check for free movement of
bearing cross as bearing caps are assembled.
4. Install snap ring to contain bearing cap just installed.
Repeat procedure for other side.
5. Install outer yoke,
disassembly and repeat Steps 1-3 to install bearing
caps on outer yoke.
6. Seat all bearing caps against snap rings by supporting
cross shaft and tapping on each corner as shown.
7. When installation is complete, yokes must pivot freely
in all directions without binding. If the joint is stiff or
binding, tap the yoke lightly to center the joint until it
pivots freely.
aligning marks made
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
at
FINAL DRIVE
7
7.17