Concluding Steps; Replacing The Irmc Microsd Card; Preliminary Steps - Fujitsu PRIMERGY RX2530 M1 Upgrade And Maintenance Manual

System board and components
Destroying the defective iRMC microSD card
V
CAUTION!
The iRMC microSD card contains customer information. After replacing
the iRMC microSD card, hand the defective card over to the customer. If
the customer requests disposal of the defective iRMC microSD card,
proceed as follows:
Ê Using a pair of side-cutting pliers, cut the iRMC microSD card in half.

15.6.2.3 Concluding steps

Ê If applicable, install the riser module 3 as described in section
riser module" on page
"Reassembling" on page 54
Ê
"Connecting the server to the mains" on page 60
Ê
"Switching on the server" on page 61
Ê

15.6.3 Replacing the iRMC microSD card

Upgrade and Repair Unit
(URU)
Tools: a pair of side-cutting pliers

15.6.3.1 Preliminary steps

"Locating the defective server" on page 45
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the server from the mains" on page 49
Ê
"Getting access to the component" on page 49
Ê
Ê If applicable, remove the riser module 3 as described in section
a riser module" on page
326
63.
62.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Installing a
"Removing
RX2530 M1