Preliminary Steps; Removing A Power Supply Unit - Fujitsu PRIMERGY RX2530 M1 Upgrade And Maintenance Manual

6.3.1

Preliminary steps

Ê Only when replacing a power supply unit in a non-redundant configuration:
"Shutting down the server" on page 48
6.3.2

Removing a power supply unit

Ê Remove the power cord from the dedicated power supply unit as described
in section "Disconnecting the server from the mains" on page
Figure 35: Unlocking and removing the power supply unit
Ê Push the handle of the power supply unit halfway upward in the direction of
the arrow (1).
Ê Push the lock in direction of the arrow (2).
Ê Grip the handle and pull out the power supply unit in the direction of the
arrow (3).
V
CAUTION!
Never leave the bay for the power supply unit empty for more than two
minutes during operation. Otherwise, excessive temperatures could
damage system components.
RX2530 M1
Upgrade and Maintenance Manual
Power supply
49.
111