Alignment Adjustment Procedure - Fuji Xerox Color C60 System Administrator Manual

Image Registration Setups

Alignment Adjustment Procedure

Note
Adjust Side 1 first and then match Side 2 to Side 1. When accounting for paper size
tolerances, the most accurate image alignment results are from folding the sheets in
half instead of using the 10 mm from edge.
1. Press the Log In/Out button, and enter the System Administrator mode.
2. Select Tools > System Settings.
3. Select the Common Service Settings followed by the Maintenance Settings.
4. Use arrows to scroll down the page of selections.
5. Select Alignment Adjustment.
6. Select Alignment Adjustment Type Setup and press Change Settings.
7. Select Type.
8. Touch Change Settings to assign a type name.
9. Press Save.
Note
Use a name such as "A4 Plain" to indicate the paper type in the tray.
10. Press Sample Printout.
11. Select the paper tray from which you are printing and select 1-Sided. Using the
Number of Sheets option, run at least 3 sheets.
12. Press the Start button.
The current sample output is printed.
Note
If the position of the sample output is correct, a line prints at a position 10 mm from
the edge of the paper. If the position of the line on the sample output is misaligned,
make adjustments accordingly. Two lines print on the image of side 1 and one line
prints on the image of side 2 of the sample to indicate the paper feed direction.
13. Make adjustments to the image in this order: Perpendicular, Skew, Magnification,
and Print Position.
14. Select Save.
15. Repeat steps 12 through 14 until Side 1 reaches the desired state.
16. Select 2-Sided print and align Side 2 to match Side 1.
Note
Hold the sheet up to a light source where you can see through the sheet. This will
help you match the images on both sides.
17. After you finish making adjustments, print another output sample by pressing
Sample Printout and verify the adjustment results.
18. Make adjustments again if necessary.
8-2 Xerox ® Color C60/C70 Printer
System Administrator Guide