Enabling Extensible Service Registration; Auxiliary Interface Kit - Fuji Xerox Color C60 System Administrator Manual

Customization and Expansion
1. In CentreWare Internet Services, click Properties > Services > Machine Software
> Manual Upgrade.
2. Under Manual Upgrade, click Choose File, then locate the
InstallCustomServices.dlm file for the custom application you want to install.
3. When you locate the file, click Open, then click Install Software.

Enabling Extensible Service Registration

To enable extensible service registration:
1. In CentreWare Internet Services, click Properties > General Setup > Extensible
Service Setup.
Note
If Extensible Service Setup does not display, the custom services software file was
not installed correctly or the installation failed.
2. Under Setup, click Edit.
3. Select the services you want to enable and click Apply.
4. Under Enable Extensible Services, select Export password to Extensible Services.
5. Under Browser Settings, select Enable the Extensible Services Browser if necessary.
6. Select Verify server certificates if necessary.
7. To configure proxy settings, under Proxy Server, select Use Proxy Server.
8. Next to Proxy Setup, select Same Proxy for All Protocols to use the same settings
for HTTP and HTTPS. Select Different Proxy for Each Protocol to enter separate
server addresses for HTTP and HTTPS.
9. Type your HTTP and HTTPS server address and port number.
10. Click Apply.

Auxiliary Interface Kit

An Auxiliary Interface Kit, or a Foreign Device Interface kit, is a third-party access and
accounting device such as a coin-operated printer accessory or a card reader that can
be attached to the printer. Installation instructions are included with the Foreign Device
Interface Kit. After the kit is installed, you must enable and configure the device at the
Control Panel.
16-2 Xerox ® Color C60/C70 Printer
System Administrator Guide