Editing Snmp V3 Settings; Adding Ip Trap Destination Addresses - Fuji Xerox Color C60 System Administrator Manual

Network Configuration
6. Type the System Administrator's Login ID.
7. Click Apply.

Editing SNMP v3 Settings

Note
Before SNMPv3 can be enabled, a digital certificate must be installed on the printer and
SSL must be enabled.
To edit SNMP v3 properties:
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols >
SNMP Configuration.
2. Under SNMP Properties, click Edit SNMP v3 Properties.
3. Under Administrator Account, click Account Enabled to create the administrator
account.
4. Type an Authentication Password then confirm it. The Authentication Password
must be at least eight characters in length and can include any characters except
control characters. This password is used to generate a key used for authentication.
5. Type a Privacy Password and confirm it. The Privacy Password is used for encryption
of SNMPv3 data. The password used to encrypt the data needs to match with the
Server.
6. Under Print Drivers/Remote Clients Account, click Account Enabled.
7. Click Apply.

Adding IP Trap Destination Addresses

To configure IP trap destinations:
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols >
SNMP Configuration.
2. Click Advanced at the bottom of the page.
3. Under Trap Destination Addresses, click Add UDP IPv4 Address or Add UDP IPv6
Address.
4. Type the IP address of the host running the SNMP manager application to be used
to receive traps.
Note
Port 162/UDP is the default port for traps. Select v1 or v2c based on what the trap
receiving system supports.
5. Under Traps, select the type of traps to be received by the SNMP manager.
6. Click Apply.
5-8 Xerox ® Color C60/C70 Printer
System Administrator Guide