Ip Filter - Fuji Xerox DocuCentre S2420 User Manual

RARP
Automatically acquires the IP address from the RARP server.
DHCP/AutoNet
Automatically acquires the IP address, subnet mask, and gateway address from the DHCP
server.
If communication with the DHCP server fails, the AutoIP function is activated to allocate
an IP address (169.254.xxx.xxx). If communication with the DHCP server is later re-
established, the settings are reacquired from the DHCP server.
Control Panel
The setting used to set the IP address, subnet mask, and gateway address manually.
IP Address
When [Get IP Address] is set to [Control Panel], the IP address is set by manual input from
the numeric keypad.
Note
Subnet Mask
When [Get IP Address] is set to [Control Panel], the subnet mask is set by manual input from
the numeric keypad.
Note
Gateway Address
When [Get IP Address] is set to [Control Panel], the gateway address is set by manual input
from the numeric keypad.
Note
IPv6
Sets IPv6.
Set IPv6
Sets whether to use IPv6.
You can select [Disable] or [Enable].
[Disable] is set at the time of factory shipment.
IP Address
Use the numeric keypad to enter the IP address.
Prefix
Use the numeric keypad to set the prefix length of the IP address (between 1 to 128).
Gateway Address
Use the numeric keypad to enter the gateway address.

IP Filter

Sets whether to restrict the IP addresses that can access the machine.
Note
• Enter the IP address in the format xxx.xxx.xxx.xxx, where each 'xxx' is a value between 0 and 255.
• Enter the subnet mask in the format xxx.xxx.xxx.xxx, where each 'xxx' is a value between 0 and 255.
• Enter the gateway address in the format xxx.xxx.xxx.xxx, where each 'xxx' is a value between 0 and
255.
• The IP filter is a function used to suppress printing using TCP/IP.
• This setting is activated after restarting the machine.
Wired Network
9
185