Fax Receive Settings; Number Of Calls In Auto Reception - Sharp MX-3070N User Manual

SYSTEM SETTINGS►SETTING MODE FOR FAX
Recall in Case of Line Busy
This program is used to set the number of recall attempts and the interval between recall attempts when a transmission
is not successful due to the line being busy or other reason.
Number of Times to Recall When Line is Busy
This setting specifies whether or not recalling is performed when the line is busy. During recalling, you can set the
number of recall attempts. Any number from 1 to 15 can be selected.
Interval to Wait Between Recall Attempts (min.) When Line is Busy
The interval between recall attempts can be set. Any number of minutes from 1 to 15 can be selected.
When this setting is enabled, note that the machine will not attempt the call again when manual transmission or direct
transmission is used.
Recall in Case of Communication Error
This determines how many times the machine will automatically attempt the call again if a fax transmission fails due to a
communication error.
Number of Times to Recall in Case of Error
Specify how many times the machine will attempt the call again when a communication error occurs. During recalling,
you can set the number of recall attempts. Any number from 1 to 15 can be selected.
Interval to Wait Between Recall Attempts (min.) in Case of Error
The interval between recall attempts can be set. Any number of minutes from 1 to 15 can be selected.
When this setting is enabled, note that the machine will not attempt the call again when manual transmission or direct
transmission is used.
Disable Fax Broadcasting
Disables facsimile broadcasting.

Fax Receive Settings

Settings for fax transmission can be configured.

Number of Calls in Auto Reception

Allows you to set a number of ringing tones to sound (between 0 and 15 times) until the auto receiving facsimile starts
automatic fax reception.
If you select "0" for the number of rings, the machine will immediately answer and begin fax reception without ringing in auto
reception mode.
2-Sided Printing of Received Data
This is used to have received faxes printed on both sides of the paper.
When this setting is enabled and a fax consisting of 2 or more pages is received (the pages must be the same size), the
pages are printed on both sides of the paper.
Auto Receive Reduce Setting
When a fax is received that includes printed information such as the sender's name and address, the received image is
slightly larger than the standard size. This setting is used to automatically reduce the image to fit the standard size.
• If Auto Receive Reduce is disabled, the edges of the image outside the standard size will be cut off. However, the image
will be clearer because it will be printed at the same size as the original.
• Standard sizes are sizes such as 8-1/2" x 11" and 8-1/2" x 5-1/2" (A4 and B5).
7-169