Copy Function Settings; Default Settings; Rotation Copy Setting; Add Or Change Extra Preset Ratios - Sharp MX-3070N User Manual

Hide thumbs Also See for MX-3070N:

Table of Contents

SYSTEM SETTINGS►SYSTEM SETTINGS

Copy Function Settings

The following settings are related to copying.

Default settings selected with these settings apply to all functions of the machine (not just the copy function).

When the original and paper are placed in different orientations, this function automatically rotates the image 90 degrees

to enable correct copying on the paper.

Enable the Rotation Copy setting to copy an 5-1/2" x 8-1/2" (A5) size original on 5-1/2" x 8-1/2"R (A5R) paper.

Disable Copy in Different Size/Direction

You can prohibit copying when the orientation of the copy paper is different from the orientation of the original, or when the

appropriate copy paper size is not loaded.

This setting is enabled when

Add two enlargement preset ratio values (101% to 400%) and two reduction preset ratio values (25% to 99%).

Also, you can change the preset ratio if necessary.

Preset ratios other than added preset ratios cannot be changed.

This is used to set the maximum number that can be entered for the number of copies (number of continuous copies).

Any number from 1 to 9999 can be specified.

This is used to set the default margin shift amount. Specify a value from 0" (0 mm) to 2" (50 mm) in increments of 1/8" (3

mm) for both the front and reverse sides.

Erase Width Adjustment

This is used to set the default erase width for erase function. Specify a value from 0" (0 mm) to 1" (25 mm) in increments

of 1/8" (3 mm) for both edge erase and center erase.

Initial Multi Shot Setting

Set the default state for Multi Shot. Select the page layout for Multi Shot, whether or not borders are added, and if

added, whether the borders are solid lines or dotted lines.

"Rotation Copy Setting (page

7-77)" is disabled.

Table of Contents

Mx-3570n Mx-4070n