Preheat Mode Setting - Sharp MX-3070N User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS

Preheat Mode Setting

Set the number of minutes until preheat mode activates. Set a number from 1 to 120 in increments of 1 minute.
Preheat Mode will activate when the set duration of time elapses after printing ends and no further operations are
performed. This function reduces your power costs, and at the same time helps conserve natural resources and reduce
pollution.
Select the time that best suits the needs of your workplace.
The panel display can be turned Off in the Preheat mode.
Preheat mode cannot be disabled.
Turn off Panel Display during pre-heat mode
Set whether the lights on the operation panel turn off in preheat mode.
Auto power shut-off
When the machine is idle for the set time after printing, it enters auto power shutoff mode. In this mode, the machine
waits on standby using a minimum amount of power.
Use this setting to specify whether auto power shutoff is used.
"As soon as the remote job is finished, enter Auto power shut off mode."
This function works in Auto Power Shut-Off mode. When the machine completes a print job received from the PC or
outputs received fax data, the machine immediately returns to the Auto Power Shut-Off mode.
Fix transition time.
The Auto Power-Off transition time is fixed.
When this setting is enabled, the [Change transition time by time of day.] option is disabled.
If the Auto Power-Off is disabled, the time you have set here is disabled.
Change Transition Time by Time of Day
This function controls the transition to Auto Power Shut-Off mode optimally for each time period by analyzing the use of
the machine based on job logs obtained during a 4-week period.
When this setting is enabled, the [Fix transition time.] option is disabled.
• The image transfer control settings are not changed.
• This does not link to the Power On/Off Scheduling. If both of them are enabled, the Power On/Off Scheduling settings
precede.
• Pages are counted for each paper size separately.
• When the power supply of the machine was off, there was no job during this time.
Transition to Energy Saving and Auto Power Shut-Off modes
Pattern
Mode1 (Job Start
Priority1)
Mode2 (Job Start
Priority2)
Transition time
After 1 hour
After 30 minutes
7-152
Average outputs per
*
hour
500 or more
100 to 499