Network Settings; Standard - Sharp MX-3070N User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS

Network Settings

Standard

Select the minimum required settings for the machine connection to the network.
Connection Type
Use this setting to switch between [Wired Only], [Wired+Wireless (Access Point Mode)] or [Wireless (Infrastructure
Mode)].
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine.
DHCP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration
Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP
address.
• If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes,
printing will not be possible.
• If the machine is used on a TCP/IP network, be sure to enable the
IPv4 Address
Enter the IP address of the machine.
Subnet Mask
Enter the IP subnet mask.
Default Gateway
Enter the default gateway address.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP address of the machine.
IPv6
Enable this setting.
DHCPv6
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol) v6.
When this setting is enabled, it is not necessary to manually enter an IP address.
Manual Address/Prefix Length
Enter the IP address and the prefix length (0 to 128) of the machine.
Default Gateway
Default Gateway
• If DHCPv6 is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing
will not be possible.
• If the machine is used on a TCP/IP network, be sure to enable the
• In an IPv6 environment, the machine can use LPD or IPP protocol.
"TCP/IP (page
"TCP/IP (page
7-132
7-134)" below.
7-134)" below.