Internet Fax Settings - Sharp MX-3070N User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS

Internet Fax Settings

Settings related to the image send function (Scan, Internet fax, etc.) can be configured.
For an explanation of settings related to the fax function, see
These settings can be configured when the Internet fax expansion kit is installed.
Preference
Configures the default settings for Internet fax.
Resolution Setting
Apply the Resolution Set when Stored
You can apply the resolution setting that was set when the file was saved to transmission of the file.
Resolution Settings
Set the resolution used for file transmission.
H-Tone
Enable half-tones.
Auto Wake Up Print
When the [Power] button is "Off" (but the main power switch is "") and an Internet fax is received, this function activates
the machine and prints the fax.
When this function is disabled, received Internet faxes are not printed until the ([Power] button) is switched "On".
Compression Setting
This is used to set the default compression mode for Internet fax transmission.
The following settings can be configured.
• MH (G3)
• MMR (G4)
I-Fax Speaker Volume Settings
Adjusts the volume of fax receive signals and communication error signals heard through the speaker.
A fax receive signal sounds after the machine checks the mail server and retrieves received faxes. A communication
error signal sounds when a delivery failed e-mail is received from the destination Internet fax machine.
Original Print on Transaction Report
When a transaction report is printed, this is used to print part of the first page of the transmitted original on the
transaction report. Select one of the settings below.
• Always Print
• Print at Error
• Do not Print
This setting will not be effective if the next
Transaction Report Print Select Setting
Selects whether or not a transaction report will be printed, and if printed, the condition for being printed. Select a setting
for each of the following operations:
Single Sending
• Always Print
• Print Out Error Report Only
• Do not Print
Broadcasting
• Always Print
• Print Out Error Report Only
• Do not Print
Receiving
"IImage Send Settings (page
"Transaction Report Print Select Setting (page
7-96
7-165)"
7-96)" is set to "Do not Print".