Fax Receive Settings; Number Of Calls In Auto Reception; Print Style Setting - Sharp MX-5500N System Settings Manual

Registration of Own Name
Select
This is used to store sender names used in "Own
Number Select". A maximum of 18 names can be stored.
Add New
Store a sender name. A maximum of 20 characters can
be entered for the sender name. Control numbers are
from 01 to 18. The lowest number not yet in use is
automatically assigned when you begin the storing
procedure. This number cannot be changed.
Sender Name List
This shows the currently stored sender names.
A sender name can be selected to delete it.

Fax Receive Settings

Settings for fax reception can be configured.

Number of Calls in Auto Reception

This setting is used to select the number of rings on
which the machine automatically receives a call and
begins fax reception in auto reception mode.
The "Number of Calls in Auto Reception" that can be set
in each country are shown in the following table.
Country Differentiation Table
United Kingdom, France,
Germany, Sweden, Italy, Spain,
Netherlands, Thailand, Hong Kong,
Saudi Arabia, South Africa,
Hungary, Czech Republic,
Slovakia, Poland, Greece, Russia,
Philippines, Indonesia
Australia, New Zealand
Singapore
Malaysia, India, Canada, Taiwan
If you select "0" for the number of rings, the machine
will immediately answer and begin fax reception
without ringing in auto reception mode.
The number of rings
0 to 9
2 to 4
0 to 3
0 to 15
105
Switching from Manual to
Automatic Reception
This setting can only be activated in France.
When a fax is received in manual reception mode, you
have have the machine automatically switch to auto
reception. The number of rings on which switching to auto
reception takes place can be set to any number from 1 to 9.
Duplex Reception Setting
This is used to have received faxes printed on both sides
of the paper.
When this setting is enabled and a fax consisting of 2 or
more pages is received (the pages must be the same
size), the pages are printed on both sides of the paper.
Auto Receive Reduce Setting
When a fax is received that includes the sender's name
and number, the received image is slightly larger than
the standard size. This setting is used to automatically
reduce the image to fit the standard size.
• If Auto Receive Reduce is disabled, the edges of
the image outside the standard size will be cut off.
However, the image will be clearer because it will
be printed at the same size as the original.
• Standard sizes are sizes such as A4 and B5
(8-1/2" x 11" and 8-1/2" x 5-1/2").

Print Style Setting

This setting determines the paper selection condition
when printing received faxes. Select one of the three
conditions below.
Print Actual Size Cut off Disabled
The received fax image is printed at full size without
dividing it onto multiple sheets of paper. If the same size
of paper or larger paper is not loaded, the fax will be
received in memory and will not be printed until a
suitable size of paper is loaded.
However, if the received fax is longer than A3 (11" x 17")
size, it will be automatically divided onto multiple sheets
of paper.
Print Actual Size Cut off Enabled
Each received image is printed at full size. If necessary,
the image is divided onto multiple sheets of paper.
Auto Size Select
Each received image is printed at full size when
possible. When not possible, the image is automatically
reduced before printing.