When The Line Is Busy; When A Communication Error Occurs - Sharp MX-3070N User Manual

FACSIMILE►BASIC TRANSMISSION METHODS

WHEN THE LINE IS BUSY

If the line is busy when you send a fax, transmission will be attempted again automatically after a preset interval. This
function only operates in memory transmission mode. In direct transmission mode or manual transmission mode, the
transmission will be canceled. Wait for a brief period and then try sending the fax again.
To cancel transmission:
Do so from the job status screen.
► STOPPING/DELETING A JOB IN PROGRESS OR RESERVED (page 1-73)
To set the number of recall attempts and the interval between attempts when the connection cannot be established because
the line is busy, or for other reasons:
In "Setting mode (administrator)", select [System Settings] → [Image Send Settings] → [Fax Settings] → [Send Settings] →
[Recall in Case of Line Busy].
The factory default setting is two attempts at 3-minute intervals.

WHEN A COMMUNICATION ERROR OCCURS

If a communication error occurs or the other fax machine does not answer the call within a preset period of time,
transmission will automatically be attempted again after a preset interval. This function only operates in memory
transmission mode.
In direct transmission mode, transmission will not automatically be attempted again
To cancel transmission:
Do so from the job status screen.
► STOPPING/DELETING A JOB IN PROGRESS OR RESERVED (page 1-73)
To set the number of recall attempts and the interval between attempts when a transmission fails due to an error:
In "Setting mode (administrator)", select [System Settings] → [Image Send Settings] → [Fax Settings] → [Send Settings] →
[Recall in Case of Communication Error].
The factory default setting is two attempts at 3-minute intervals.
4-26