Key Function; Led Function; Lcd Function; Online Mode - Toshiba B-SX4 Series Key Operations Manual

5. ONLINE MODE

5.1 KEY FUNCTION

[FEED] key:
[RESTART] key:
[PAUSE] key:

5.2 LED FUNCTION

[POWER] LED:
[ON LINE] LED:
[ERROR] LED:

5.3 LCD FUNCTION

The LCD displays the message which indicates the printer status.
LCD Size: 16 digits × 2 lines
(1) Feeds one sheet of paper. This key can be used to eject one sheet of paper.
This key can also be used to adjust the paper to the proper position when the
paper is not properly positioned. If printing is attempted when the paper is
not properly positioned, printing is not performed at the proper position. One
or two sheets of paper should be fed to adjust the paper position before
printing.
(2) Prints the data in the image buffer on one label according to the system mode
setting.
NOTE: A clear command or a command for drawing should not be sent
during printing by the [FEED] key. If it is sent, the correct layout wil
be lost, and the label will not be printed properly. If an issue is
performed by the [FEED] key while the data is being drawn in the
image buffer, the correct layout may be lost.
* For the following, refer to the parameter setting section.
• The procedure for using the label having a label pitch of less than 38 mm in
the cut issue mode when the swing cutter is used
• The procedure for using the label having less than the min. label pitch for
each issue speed in the cut issue mode when the rotary cutter is used.
(1) Resumes printing after a temporary stop of label printing or after an error.
(2) Places the printer in the usual initial state which is obtained when the power is
turned on.
(3) Programs various parameters.
(1) Stops label printing temporarily.
(2) Programs the threshold values.
Indicates that the printer power is ON or OFF.
Indicates that the printer is ready for communication.
Indicates that the printer is in an error state.
- 3 -