System Mode For Users (Operable System Mode Menus Are Limited.) - Toshiba B-SX4 Series Key Operations Manual

Continued from the previous page.
[RESTART]
<10>RFID

System mode for users (Operable system mode menus are limited.)

Power OFF
[RESTART]
<1>DIAG.
[RESTART]
<2>PARAMETER SETTING
[RESTART]
<3>ADJUST SET
[RESTART]
<4>TEST PRINT
[RESTART]
RFID read test, RFID module type selection,
[FEED]
RFID carrier sense setting, RFID tag type selection, Max. number of
RFID issue retries, RFID error tag detection, Max. number of RFID read
retries, RFID read retry time-out, Max. number of RFID write retries,
[FEED]
RFID write retry time-out, RFID adjustment for retry, RFID wireless
power level, AGC threshold setting, Channel setting
While holding the [FEED] and [RESTART] keys down, turn the power on.
Maintenance counter/Various parameters printout,
Printer self-test operation and results printout,
[FEED]
Thermal head broken dots check
Installed solenoid type setting, Ribbon saving system setting
[FEED]
Feed fine adjustment, Cut position fine adjustment (or strip
position fine adjustment), Back feed fine adjustment,
X-coordinate fine adjustment, Print density fine adjustment
(Thermal transfer/Direct thermal print mode), Ribbon motor drive
voltage fine adjustment, Transmissive sensor manual threshold
[FEED]
fine adjustment, Reflective sensor manual threshold fine
adjustment,
Parameter setting, 1-dot slant line printout, 3-dot slant line
printout, Character printout, Bar code printout, Non-printing
[FEED]
Automatic printout for the assembly process (Transmissive
sensor/Reflective sensor), Factory pattern printout
- 38 -