Toshiba B-SX4 Series Key Operations Manual page 84

[Procedure for label having less than the min. label pitch for each issue speed when the rotary
cutter is used]
When the following conditions are all met, the cut operation for the last label to be cut is as
follows.
Forward feed to the cut position → Cut with feeding → Feed stops →
Head lifted → Reverse feed to the home position → Head lowered
Conditions: Issue Command, Feed Command, and Eject Command received.
* For the Issue Command, this procedure is effective only for the last label to be cut
when the next Issue Command is not received.
* The head is lifted/lowered only when the optional ribbon save module is attached
and the ribbon saving system is set to ON in the parameter setting. When the
ribbon save module is not installed, the head-up/down operations are not
performed. See "NOTES" below.
NOTES: 1. If the head is being lifted up when the edge of the label which is
Label pitch: Less than the min. label pitch for each issue speed,
cut performed, transmissive sensor designated, cut position fine
adjustment of ±10.0 mm or less, and issue mode "C"
being ejected passes the paper feed roller, the sensor may not be
able to detect an error even if it occurs (a feed cannot be performed
more).
2. If the head-up solenoid temperature is high when a cut issue is
about to be performed with the head lifted, the head may not be
lifted.
- 81 -