Various Parameters Check Contents - Toshiba B-SX4 Series Key Operations Manual

Maintenance Counter
Head-up solenoid drive time
RS-232C hardware error
count
System error count
Momentary power interruption
count
Number of successful RFID
write
Number of failure in RFID
write

(2) Various parameters check contents

Item
[PC] FEED
CUT
BACK
TONE(T)
TONE(D)
RBN(FW)
RBN(BK)
[KEY] FEED
CUT
BACK
TONE(T)
TONE(D)
RBN(FW)
RBN(BK)
X ADJ.
THRESHOLD<R>
THRESHOLD<T>
Counts when the ribbon saving operation is performed.
For B-SX4:
When the power is off, a drive time of 32 seconds or less is
rounded down and backed up.
For B-SX5:
When the power is off, a drive time of 27 seconds or less is
rounded down and backed up.
Counts when a parity error or a framing error occurs.
* When data of several bytes is transmitted continuously,
counting is performed per byte.
Counts when a system error of No. 22 listed in section 5.10
"LCD MESSAGES AND LED INDICATIONS" occurs.
Counts when a momentary power interruption occurs.
Counts when an RFID write has succeeded.
Counts when an RFID write has failed.
Contents
Feed fine adjustment
Cut position (or strip position) fine
adjustment
Back feed fine adjustment
Print density fine adjustment
(Thermal transfer print mode)
Print density fine adjustment
(Direct thermal print mode)
Ribbon motor drive voltage fine
adjustment (Rewind)
Ribbon motor drive voltage fine
adjustment (Back tension)
Feed fine adjustment
Cut position (or strip position) fine
adjustment
Back feed fine adjustment
Print density fine adjustment
(Thermal transfer print mode)
Print density fine adjustment
(Direct thermal print mode)
Ribbon motor drive voltage fine
adjustment (Rewind)
Ribbon motor drive voltage fine
adjustment (Back tension)
X-coordinate fine adjustment
Reflective sensor manual
threshold fine adjustment
Transmissive sensor manual
threshold fine adjustment
- 49 -
Count Conditions
Remarks
-50.0 mm to +50.0 mm
-50.0 mm to +50.0 mm
-9.9 mm to +9.9 mm
-10 to +10 step
-10 to +10 step
-15 to +6 step
-15 to +10 step
-50.0 mm to +50.0 mm
-50.0 mm to +50.0 mm
-9.5 mm to +9.5 mm
-10 to +10 step
-10 to +10 step
-15 to +0 step
-15 to +0 step
-99.5 mm to +99.5 mm
0.0 V to 4.0 V
0.0 V to 4.0 V
(See NOTE.)
(See NOTE.)
(See NOTE.)