Installed Solenoid Type Setting (Solenoid); Ribbon Saving System Setting (Ribbon Save) - Toshiba B-SX4 Series Key Operations Manual

(12) Installed solenoid type setting (SOLENOID)

RESTART
FEED

(13) Ribbon saving system setting (RIBBON SAVE)

RESTART
FEED
(14) Control code selection (CODE)
[RESTART]
CODE
[RESTART]
CODE ESC,LF,NUL
[RESTART]
CODE
[RESTART]
CODE
CONTROL CODE1 1B
CONTROL CODE2 0A
CONTROL CODE3 00
PEEL OFF STS OFF
• TYPE 1: TDS-12C (wound with blue tape) is installed.
• TYPE 2: TDS-16A (stronger pull force type wound with black tape) is
installed.
NOTE: If this setting does not match the actually installed solenoid
type, ribbon saving function may not be able to work.
• OFF: The ribbon saving system is not used.
• ON (LBL): The ribbon saving system is used when the head lever
position is "LABEL".
• ON (TAG): The ribbon saving system is used when the head lever
position is "TAG".
NOTE: If the ribbon saving system is used unless the ribbon saving
module has been installed, the ribbon may sag during
feeding/printing, and printing cannot be performed properly.
Be careful with this setting
AUTO
[FEED]
[FEED]
{ | }
[FEED]
MANUAL
[FEED]
[PAUSE]
[PAUSE]
[PAUSE]
[PAUSE]
- 67 -
[RESTART]
CONTROL CODE1 02
[FEED] [RESTART]
CONTROL CODE1 01
[FEED] [RESTART]
CONTROL CODE1 00
[FEED] [RESTART]
CONTROL CODE1 FF
[FEED] [RESTART]
CONTROL CODE1 FE
[FEED]