Strip Position Fine Adjustment - Toshiba B-SX4 Series Key Operations Manual

[Strip position fine adjustment]

+0.0 mm
+3.0 mm
- 3.0 mm
4 mm
3 mm
Printing in strip issue mode is stopped at the position where the
distance from the middle point of the gap between labels to the
end of the strip shaft is 4 mm, since the gap between labels is
assumed to be 2 mm.
When the print stop position is not proper due to a greater gap,
the print stop position should be adjusted using the strip
2 mm
position fine adjust function.
- 82 -