Feed Fine Adjustment; Setting Contents - Toshiba B-SX4 Series Key Operations Manual

5.8.2

Setting Contents

For details, refer to section 6.4 "Various Fine Adjustment Values Setting" in chapter 6 "System
Mode".
(1) Feed fine adjustment (FEED ADJ.)
-50.0 mm to +50.0 mm (in 0.5 mm units)
(2) Cut (strip) position fine adjustment (CUT ADJ.)
-50.0 mm to +50.0 mm (in 0.5 mm units)
(3) Back feed fine adjustment (BACK ADJ.)
-9.5 mm to +9.5 mm (in 0.5 mm units)
(4) X-coordinate fine adjustment (X ADJUST)
-99.5 mm to +99.5 mm (in 0.5 mm units)
(5) Print density fine adjustment (Thermal transfer print mode) (TONE ADJ.<T>)
-10 step to +10 step (in units of step)
(6) Print density fine adjustment (Direct thermal print mode) (TONE ADJ.<D>)
-10 step to +10 step (in units of step)
(7) Ribbon motor drive voltage fine adjustment (Rewind) (RBN ADJ <FW>)
-15 step to +0 step (in units of step)
(8) Ribbon motor drive voltage fine adjustment (Back tension) (RBN ADJ <BK>)
-15 step to +0 step (in units of step)
(9) Reflective sensor manual threshold fine adjustment (THRESHOLD <R>)
0.0 V to 4.0 V (in 0.1 V units)
(10) Transmissive sensor manual threshold fine adjustment (THRESHOLD <T>)
0.0 V to 4.0 V (in 0.1 V units)
- 20 -