Table of Contents
Advertisement
6 ONLINE MODE
6.1 KEY FUNCTION
The printer behavior is not guaranteed when undefined key is operated.
6.1.1 Online Mode Screen
Key
Function
(1) Feed one piece of media to eject one piece of media.
[FEED]
(2) Prints the data in the image buffer on one piece of media according to the system
* For details of the following cases, refer to the parameter setting section.
* In the strip mode, the printer feeds labels even when the peel-off sensor is detecting a
* When the Media Load parameter is enabled, a media feed is performed to find the
(1) Resume printing after a temporary stop of printing or after an error.
[RESTART]
(2) Place the printer in the initial state after startup.
(3) Place the printer in the user system mode.
(1) Stop label printing temporarily.
[PAUSE]
(2) Sets the threshold value.
Use the media to feed to the print start position. If printing is attempted with the media
improperly positioned, print data is not printed at the correct position. One or two
pieces of media need to be fed to adjust the print start position before printing.
mode setting.
Note: A Clear Command or a command for drawing shall not be sent to the printer while it is
printing by pressing the [FEED] key. If a command is sent, the layout will be destroyed. Also, if
printing is performed by pressing [FEED] key while the data is being drawn in the image
buffer, the layout may be destroyed.
• How to issue the label stock having the label pitch of 25.4 mm or less in the cut issue
mode when the disc cutter is used.
• How to issue the label stock having the minimum label pitch or less for each print
speed in the cut issue mode when the rotary cutter is used.
label.
print start position depending on the condition. For details, refer to Section 8.5.1
MEDIA LOAD.
11
Advertisement
Table of Contents
