Toshiba B-SX4 Series Key Operations Manual page 19

(26) Plug-and-play operation setting (PLUG & PLAY)
• ON: Plug-and-play operation is enabled.
• OFF: Plug-and-play operation is disabled.
(27) Label end/ribbon end process setting (LBL/RBN END)
• TYPE1: When a label end or ribbon end state is detected, the printer stops even if it is
printing a label.
• TYPE2: When a label end or ribbon end state is detected, the printer prints the current
label as far as possible, then stops.
(28) Pre-peel-off process setting (PRE PEEL OFF)
• OFF: Pre-peel-off operation is not performed.
• ON: Pre-peel-off operation is performed.
(29) Back feed speed setting (BACK SPEED)
• STD: 3 ips
• LOW: 2 ips
(30) MaxiCode specification setting (MAXI CODE)
• TYPE1: Compatible with the current version
• TYPE2: Special specification
(31) Print head type setting (THERMAL HEAD)
• V1: Current type print head (B-SX4: TPH104R2/B-SX5: TPH128R4)
• V2: Enhanced type print head (B-SX4: TPH104R7 or equivalent,
(32) System mode password operation setting (PASSWORD)
• OFF: Password is not asked to enter the system mode.
• ON: Password is asked to enter the system mode.
Password: 4-digit hex value
(33) XML function setting (XML) Note: This function is supported only by V4.4A.
• STD: Standard specification
• ORACLE: Specification for Oracle
B-SX5: TPH128R5 or equivalent)
- 16 -