Online Mode; Key Function; Online Mode Screen - Toshiba B-EX Series Key Operation Specification

6 ONLINE MODE

6.1 KEY FUNCTION

The printer behavior is not guaranteed when a undefined key is operated.

6.1.1 Online Mode Screen

Key Function
[FEED] (1) Feeds and ejects one piece of the media.
(2) Prints the data in the image buffer on one piece of the media according to the
* For details of the following cases, refer to the parameter setting section.
* In the strip mode, the printer feeds labels even when the peel-off sensor is detecting a
* When Media Load parameter is enabled, media feeding is performed to find the print
[RESTART] (1) Resumes printing after a temporary stop of printing or after an error.
(2) Places the printer in the initial state after startup.
(3) Places the printer in the user system mode.
[PAUSE] (1) Stops label printing temporarily.
(2) Programs the threshold value.
[MODE] (1) Places the printer in the user system mode.
[CANCEL] (1) Clears the job.
[ENTER] (1) Displays help messages.
(2) Saves the log/receive buffer data.
(3) Places the printer in the RFID calibration mode.
[UP] (1) Places the printer in the Information mode.
Supported model:
B-EX4T1-G/T-QM/CN C1.0I or later, B-EX4T2-G/T-QM/CN C1.0F or later,
B-EX4T2-H-QM/CN C1.1A or later, B-EX4D2-G-QM/CN D1.1 or later
[DOWN] (1) No function.
[LEFT] (1) No function.
[RIGHT] (1) Displays help messages.
This is also sed to adjust the media to the proper position. If printing is attempted
with the media improperly positioned, print data is not printed at the correct position.
One or two pieces of the media need to be fed to adjust the print start position before
printing.
system mode setting.
Note:
Do not send a clear command or a drawing command to the printer from the host
during printing by pressing the [FEED] key. Otherwise, the layout will be destroyed.
Also, if printing is performed by pressing the [FEED] key while the data is being
drawn in the image buffer, the layout may be destroyed.
• How to issue the label stock having a label pitch of 25.4 mm or less in the cut issue
mode when the disc cutter is used.
• How to issue the label stock having the minimum label pitch or less for each print
speed in the cut issue mode when the rotary cutter is used.
label.
start position depending on the condition. For details, refer to Section 8.4.1.1 MEDIA
LOAD.
Supported model: B-EX4T1-G/T-QM/CN C1.4 or later
(B-EX4T1 Japan model with firmware V1.0I only)
6