Setting For Forward Feed Standby After An Issue (Forward Wait); Setting For Forward Feed Standby Action (Fw/Bk Act.) - Toshiba B-SX4 Series Key Operations Manual

(9) Setting for forward feed standby after an issue (FORWARD WAIT)

[RESTART]
FORWARD WAIT OFF
[RESTART]
FORWARD WAIT ON
[FEED]
POSITION +0.0mm
[FEED]
POSITION +0.5mm
[FEED]
POSITION +5.0mm
[FEED]
POSITION -5.0mm
[FEED]
POSITION -4.5mm
[FEED]
POSITION -0.5mm

(10) Setting for forward feed standby action (FW/BK ACT.)

RESTART
FEED
(11) Setting for head-up operation in cut issue mode, or for using the rewinder (HU CUT/RWD.)
RESTART
FEED
[FEED]
[FEED]
[PAUSE]
[RESTART]
[RESTART]
[RESTART]
[RESTART]
[RESTART]
[RESTART]
• MODE 1: Stops after 13.7-mm forward feed.
• MODE 2: Stops after 6-mm back feed and 3-mm forward feed. (Only
when the cut mode, thermal transfer, and feed gap sensor
are selected.) In other cases, the printer stops after 13.7-mm
forward feed.
• OFF: Head-up operation is not performed/the rewinder is not used.
• ON: Head-up operation is performed/the rewinder is used.
When a cut issue is performed, this head-up operation setting takes
effect. When a batch issue is performed, the rewinder setting takes
effect.
NOTE: If the solenoid temperature is high when a cut issue is about to
be performed with the head lifted, the head may not be lifted.
- 66 -
• OFF: Not performed
• ON: Performed
Setting for the fine adjustment value for the
stop position after a forward feed standby:
-5.0 mm to +5.0 mm
+: Performs a longer length of a forward
feed, then stops.
-: Performs a shorter length of a forward
feed, then stops.