(7)
RS-232C transmission control method selection (XON+READY)
•
XON/XOFF protocol
•
READY/BUSY (DTR) protocol
•
XON/XOFF + READY/BUSY (DTR) protocol (An XON is output when the power is on
•
XON/XOFF protocol
•
RTS protocol
(8)
Language selection for LCD messages (LCD)
•
ENGLISH
•
GERMAN
•
FRENCH
•
DUTCH
•
SPANISH
•
JAPANESE
•
ITALIAN
NOTE:
When Japanese is selected, one part of the character codes is different. For
details, refer to the External Equipment Interface Specification (TAA-1380).
(9)
Setting for forward feed standby (FORWARD WAIT)
•
ON (with automatic feed standby)
•
POSITION (Fine adjustment value setting for the stop position after a forward feed)
•
OFF (without automatic feed standby)
NOTE:
When it is set to ON, if the printer is in the idle state for 1 second or more after a
label is issued, the printer automatically performs an approximately 13.7-mm
forward feed, then stops.
(10) Setting for the forward feed standby action (FW/BK ACT.)
•
MODE 1
(Stops after 13.7-mm forward feed.)
•
MODE 2
(Stops after 6-mm back feed and 3-mm forward feed.
(Only when the cut mode, thermal transfer, and feed gap sensor are
selected.) In other cases, the printer stops after 13.7-mm forward feed.)
(11) Setting for head-up operation in cut issue mode, or for using the rewinder in batch issue
mode (HU CUT/RWD.)
•
ON (The head is lifted, or the rewinder is used.)
•
OFF (The head is not lifted, or the rewinder is not used.)
(12) Installed solenoid type setting
•
TYPE 1
•
TYPE 2 (Stronger pull force type)
(An XON is not output when the power is
on and an XOFF is not output when the
power is off)
(An XON is not output when the power is
on and an XOFF is not output when the
power is off)
and an XOFF is output when the power is
off)
(An XON is output when the power is on
and an XOFF is output when the power is
off)
(An XON is not output when the power is
on and an XOFF is not output when the
power is off)
- 14 -