Muratec MFX-2830 Operation Manual page 452

In This
Case...
■ Copy-Related
Error message
ADF is unavailable. Set the docu-
ment on the FBS glass.
Cannot use bypass tray for duplex
copy
Enter hold time
Enter reduce/enlarge
Load paper in bypass tray
Load paper for duplex copying
Paper inappropriate for duplex copy
No Document stored in memory
Not enough memory
Not enough memory
The last %1 page was erased
Please copy again
Option not valid with....
5-32
In This Case... Maintenance and Troubleshooting
●
Countermeasure
A document has been placed in the ADF during series copy. Set the
document on the document glass.
The bypass tray cannot be used for duplex copies. Choose a cas-
sette.
The "last job hold time" is set to 0 minute. The hold time needs to
be set to use the last job function.
Custom paper cannot be copied with an automatic zoom ratio. En-
ter reduce/enlarge ratio.
The paper in the bypass tray has run out. Supply paper to the by-
pass tray.
Duplex copy is not available for the paper mentioned in the mes-
sage. Select another type of paper.
The last job document has been deleted because a lot of memory
was used for reservations and proxy reception.
The document could not be accepted due to insufficient memory.
Set the document again after the current operation finishes.
Copying was interrupted due to insufficient memory. Restart copy-
ing from the displayed page.
Attempting to combine a function which cannot be set at the same
time with ... Re-enter the setting.
Reference page
2-44
1-32
2-64
2-18
1-32
2-67
2-64
2-88