Muratec MFX-2830 Operation Manual page 449

■ Fax-Related
Error message
ADF used in feeder command
Already stored
Cannot select mode during Fax &
Copy
Cannot store in security box
Cannot use numeric keypad
Command is full
Communication error
Document full
Document stored
Enter sub-address
Incorrect passcode
Input ratio (100-400%)
Invalid I.D. code
Countermeasure
One or more of the following operations was attempted either dur-
ing real-time transmission or when real-time transmission was
reserved.
· Press .
STOP
· Transmission to a different destination was instructed.
· To store a document reserved for polling was instructed.
Wait for the real-time transmission to finish, or cancel the reser-
vation for real-time transmission before operating the unit.
The same number has already been entered. Check the number
and re-enter it.
Attempting to change to the fax screen during Fax & Copy. Change
to the fax screen after Fax & Copy finishes.
The box selected for F-Code document storage or deletion is a se-
curity box. Select a bulletin box.
Attempting to enter a direct dial number for a location using the
F-Code box relay box. Enter the location using the one-touch key,
the speed-dial, or a group number. The numeric keypad cannot be
used.
The number of reserved command has exceeded 100. Up to 100 re-
served commands can be registered.
Wait until the current reserved operations are completed before
attempting the operation. Or, use real-time transmission.
A communication error occurred. Check the contents of the com-
munication error and repeat the operation.
Press if the "Communication error" does not disappear.
STOP
Registered 40 or more documents in the box designated for batch
transmission. Print out the batch transmission document list.
Check the registered documents to make the number of documents
less than 39 by deletion.
A polling reservation has already been stored. Normally, only one
polling reservation can be stored.
Batch transmission has been stored. When a batch transmission
has been stored, the batch transmission box cannot be deleted.
No sub-address has been entered in the F-Code box. Enter the sub-
address.
Entered an incorrect passcode. Enter the correct passcode.
A ratio less than 100% was specified for enlarge transmission ra-
tio. A reduction ratio cannot be specified, so reset the number to
larger than 100%.
This message is displayed when you entered an incorrect I.D. code
in printing the document stored in F-code Box. Enter the correct
I.D. code.
Error Message
In This Case... Maintenance and Troubleshooting
●
Reference page
3-28
Getting
Started
COPY
3-128
Chapter1
COPY
3-120, 3-124
Chapter2
3-109
COPY
Chapter3
FAX
3-5
Chapter1
FAX
5-24
Chapter2
FAX
3-70
Chapter3
3-71
FAX
Chapter4
3-92
3-68
Common
Settings
3-98
In This
4-36
Case...
3-132
Appendix
3-102
5-29