Muratec MFX-2830 Operation Manual page 446

In This
Case...
T: Transmission Errors
Mode Error code
T.5.1,
T.5.2, T.5.3
T.8.10,
T.8.11
T.8.1
R: Reception Errors
Mode Error code
R.1.1
R.1.2
R.1.4
R.1.5
R.2.3
R.3.1
R.3.3
R.3.4
R.3.5
R.4.2
R.4.4
R.5.1
R.5.2
R.8.10,
R.8.11
R.8.1
5-26
In This Case... Maintenance and Troubleshooting
●
Description
The line cut off during document trans-
mission (due to a line error)
Due to a line error, communication failed
The reception mode does not match
Description
Your machine is set to manual reception or
transfer reception and is ready to receive,
but no signal comes from the sending party
Your machine's mode does not match
with the sending party's
Received Junk fax when the junk fax
block function is on (only the auto print
journal is displayed)
Pressed during reception (Only the
STOP
auto print journal is displayed)
Due to a line error, communication failed
Due to a line error, the line cut off
Pulled out the document or the Stop key
was pressed by the sending party
Due to a line error, the signal cut off (due
to line error)
Due to a line error, reception is not avail-
able even at the slowest speed (due to
line error)
Due to a memory overflow, the reception
failed
Due to a line error, the signal cut off dur-
ing reception (due to line error)
Memory overflow (only the auto print
journal is disaplayed)
The signal cut off during reception
The sending party pressed
Due to a line error, the signal cut off dur-
ing reception (due to line error)
Due to a line error, communication failed
Your machine's mode does not match
with the sending party's
Resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
Check the receiving machine. It sometimes turns out
that the receiving party is not using a fax machine.
The sending party may have made an operational
mistake. If you know whom the sending party is, ask
them to resend the document.
If you know whom the sending party is, ask them to
resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
If you know whom the sending party is, ask them to
resend the document.
If you know whom the sending party is, ask them to
resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
Check the amount of memory left and ask the send-
ing party to send the document again.
If you know whom the sending party is, ask them to
resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
STOP
If you know whom the sending party is, ask them to
resend the document. If this error occurs repeatedly,
contact your Muratec dealer.
Check the sending party's machine. For example,
their machine may not have the document in case of
polling operation.
Countermeasure
Countermeasure