Other Settings List - Muratec MFX-2830 Operation Manual

FAX
Chapter4

Other settings list

Function
# of Redials
Redial Interval
Block Junk Fax
(see page 3-156)
# of Rings
Set DRD
(see page 3-136)
Dialing Pause
High Resolustion
Rx Reduction Rate
Reduction Margin
(see page 3-50)
Paper Saving
(see page 3-51)
Rotate Tx
Quick Memory Tx
3-196
FAX Chapter4 Fax Settings
●
This sets the number of times for redial attempts when the destination
line is busy. The interval between redial attempts is set at "Redial Inter-
val".
This sets the interval between redial attempts.
This function enables you to block receipt of unnecessary faxes.
This sets the number of times the machine will ring before fax reception
when the reception mode is set to Fax or Tel/Fax.
Note
When in the Low Power mode, the number of rings will be more than the
number set.
Set this to "ON" when using DRD.
There are eight ring patterns, A to H. Select the setting most suited to
your usage conditions.
This sets the default for the dialing interval (2-10 seconds) when the
pause symbol is input.
This sets the dpi for resolution when a document is scanned for S-fine
transmission. If 600 dpi is set, the scan is sharper than with 400 dpi;
however, it may result in memory overflow when the document is sent.
Select from "Auto", which automatically selects the magnification accord-
ing to the length of the document being received, or "100%" to have all
faxes printed out at the same rate of reduction.
This sets at what point the document printout will extend to the follow-
ing page if the document being received cannot fit within the effective
recordable area.
This sets the print method for documents received.
If it is set to "H-Page Rx" and 2 pages of Letter, Legal or 11
ceived in succession, the two pages will be reduced at the appropriate rate
and printed out on one piece of paper.
If it is set to "Duplex Rx", both sides of each sheet of paper will be used for
printouts.
Note
A duplex print unit is required for duplex reception.
An Letter document can be rotated on its side, scanned and sent as
Letter size. The "Rotate Tx" setting is only effective with memory trans-
missions.
Letter
If this is set to "ON", fax transmission for multiple documents will begin
in order of page when it has been scanned and stored.
Description
Letter
Transmit
Underlined items are the factory default.
Setting
2-15 times: 2 times
1-5 minutes: 1 min-
ute
R e f e r e n c e : P a g e
3-156
1-10 times: 2 times
OFF
A~H: A
2-10 seconds: 2 sec-
onds
600dpi
400dpi
Auto
100%
0.0-3.3 inches: 1.5
inches
OFF
" "
H-Page Rx
×17 are re-
Duplex Rx
ON
OFF
ON
OFF