Linking The Remote Controller - dji INSPIRE 1 PRO User Manual

INSPIRE 1 PRO User Manual
Status LED
— Solid Red
— Solid Green
— Solid Purple
— Solid Blue
Slow Blinking Red D-D-D ......
/
Red and Green/ Red and
Yellow Alternate Blinks
RTH LED
— Solid White
Blinking White
Blinking White
The Remote Status Indicator will blink red, sound an alert, when the battery level is critically low.

Linking the Remote Controller

The remote controller is linked to your aircraft before delivery. Linking is only required when using a new
remote controller for the first time. Follow these steps to link a new remote controller:
1. Power on the remote controller and connect to the mobile device. Launch DJI GO app.
2. Power on the Intelligent Flight Battery.
3. Enter "Camera" view and tap on and then tap "Linking Remote Controller" button as shown below.
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
34
©
2015 DJI. All Rights Reserved.
Alarm
chime
chime
D-D-
D-D- chime
None
Sound
chime
D . . .
DD .. .. ..
Remote Control Calibration
Stick Mode
C1 Gimbal Pitch/Yaw
Linking Remote Controller
Remote Controller Status
The remote controller set as "Master" but it is not
connected with the aircraft.
The remote controller set as "Master" and it is connected
with the aircraft.
The remote controller set as "Slave" but it is not
connected with the aircraft.
The remote controller set as "Slave" and it is connected
with the aircraft.
Remote controller error.
HD Downlink is disrupted.
Remote Controller Status.
Initiate RTH procedure.
Send RTH command to aircraft.
Aircraft returning to Home Point.
RC Control Setting
C2 Reset gimbal yaw
You can customize the C1 and C2 buttons on the back
of the remote controller.