dji INSPIRE 1 PRO User Manual page 67

SD card slot on the camera.
Step 3- Update the Aircraft
1. Ensure the remote controller is powered off and then power on the aircraft. Upgrade will begin
automatically after aircraft is powered on.
2. It will take approximately 25 minutes to complete the firmware update. The camera status indicator
will blink green and red to indicate the upgrade is in progress and stop blinking when the update is
complete with success.
3. Check the upgrade status by opening the ".txt" file that is automatically generated after the update.
The update is successful if the text "result: successful" is in the document. Try upgrading the firmware
again if the text "result: failed" is found or the camera status indicator shows solid red.
Updating the Remote Controller Firmware
Ensure the DJI GO app has been updated to v1.2.0 before updating the remote controller. The
System Status bar in Camera View of the DJI GO App will flash several times if a firmware update is
available. Follow these steps to update the firmware via the DJI GO App.
Step 1- Check Battery and SD Card Capacity
1. The remote controller has at least 50% battery level.
2. Your mobile device is able to access the internet.
3. There is at least 30 MB of free space on your mobile device.
Step 2- Download and Update the Firmware
1. Go to the DJI GO App > Camera View > System Status bar > Overall Status. Tap Download the
firmware update package to download and update the firmware. Track the update progress from
progress bar in the DJI GO App. The status LED on the remote controller will blink blue during update
and blink green when update is complete with success.
Firmware update through the DJI GO app will not work with older versions of the remote controller
firmware. If the firmware update fails, follow the instructions below to update the firmware using the
traditional method:
a. Update the latest firmware package files from DJI official web site.
b. Extract all downloaded files into the root directory of an SD card or USB flash drive.
c. Turn off the remote controller, Insert the SD card into a SD card reader or the USB disk onto the
remote controller USB port when remote controller is turned off.
d. Power on the remote controller and wait 60 seconds until the upgrade begins. Do not power off
the remote controller during the update.
e. It will take approximately 10 minutes to complete the firmware update. The camera will sound
a beeping sound and the Status LED on the remote controller shows solid blue to indicate the
update is in progress. The Status LED on remote controller shows solid green and beeping
sound will stop if the upgrade is completed with success.
f . If you do not have a SD card reader, you may insert the SD card into the gimbal and connect the
gimbal with remote controller to upgrade the remote controller.
You will only be able to update the remote controller firmware through the DJI GO app from
this point onwards.
INSPIRE 1 PRO User Manual
©
2015 DJI. All Rights Reserved.
67