dji INSPIRE 1 PRO User Manual page 24

INSPIRE 1 PRO User Manual
Battery Level Indicators while Charging
LED1 LED2
Charging Protection LED Display
The table below shows battery protection mechanisms and corresponding LED patterns.
Battery Level Indicators while Charging
LED1 LED2 LED3
After any of the above mentioned protection issues are resolved, press the button to turn off the Battery
Level Indicator. Unplug the Intelligent Flight Battery from the charger and plug it back in to resume
charging. Note that you do not need to unplug and plug the charger in the event of a room temperature
error, the charger will resume charging when the temperature falls within the normal range.
DJI does not take any responsibility for damage caused by third-party chargers.
How to discharge your Intelligent Flight Battery:
To effectively calibrate the battery capacity, it is recommended to charge and discharge the
battery thoroughly for every 10 charge-and-discharge cycle. User should install the battery onto
the aircraft and then power on the aircraft to initiate the discharge process, discharge the battery
until the aircraft is powered off automatically. User should then fully charge the battery to ensure
the battery is working at its optimal.
Slow: Place the Intelligent Flight Battery into the Inspire 1 Pro's Battery Compartment and power
it on. Leave it on until there is less than 5% of power left, or until the battery can no longer
be turned on. Launch the DJI GO app to check battery level.
Rapid: Fly the Inspire 1 Pro outdoors until there is less than 5% of power left, or until the battery
can no longer be turned on.
24
©
2015 DJI. All Rights Reserved.
LED3 LED4
LED4 Blinking Pattern
LED2 blinks twice per second
LED2 blinks three times per second Short circuit detected
LED3 blinks twice per second
LED3 blinks three times per second Over-voltage charger detected
LED4 blinks twice per second
LED4 blinks three times per second
Battery Level
0%~25%
25%~50%
50%~75%
75%~100%
Fully Charged
Battery Protection Item
Over current detected
Over charge detected
Charging temperature is too low
(<0°C)
Charging temperature is too high
(>40°C)