Fcc Compliance - dji INSPIRE 1 PRO User Manual

INSPIRE 1 PRO User Manual
Updating Intelligent Flight Battery Firmware
The Intelligent Flight Battery is upgraded during the aircraft firmware upgrade process. It is recommended
to keep the upgrade package files in your SD card. The upgrade will start automatically after power
cycling the aircraft.
Ensure there is only one firmware package file stored on your SD card.
Only storage devices that are formatted for FAT32 and exFAT file systems are supported for
aircraft and remote controller firmware updates.
Ensure the internet connection of your mobile device is stable when downloading the firmware
update package.
Turn on Airplane Mode on your mobile device before updating the firmware, as any incoming
calls may disrupt the update process.
Do not perform firmware update while the aircraft is still flying in the air. Only carry out firmware
update when the aircraft is landed.
Be sure to update the remote controller's firmware to the latest version after you upgrade the
aircraft's firmware.
The remote controller may become unlinked from the aircraft after updating. Re-link the remote
controller and aircraft.
Confirm the update results based on the blinking pattern of camera status indicator or gimbal
sound. It is normal for the aircraft to sound or the LED to blink during the update process.

FCC Compliance

FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly roved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC Warning Message
Any Changes or modifications not expressly roved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator&
your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
68
©
2015 DJI. All Rights Reserved.