Installing The Gimbal And Camera - dji INSPIRE 1 PRO User Manual

Battery must be fully charged before using it for the first time. Refer to "Charging the Intelligent
Flight Battery" (P23) for more information .
If you have purchased the dual remote controller version, you must use the Master remote
controller to deactivate Travel Mode. Refer to "Setting Up Dual Remote Controllers Mode" (P32)
section for more information about Master remote controller.
Be sure to remove the gimbal from the aircraft before switch from Landing Mode to Travel Mode.
Place the aircraft on the smooth and reflective surface (e.g. table or tile) before switching between
the travel modes to the landing mode. Do not place the aircraft on the rough and sound-absorbing
surface (e.g. carpet) before switching between the travel modes and landing mode.

Installing the Gimbal and Camera

The following steps use the DJI MFT 15mm f/1.7 ASPH as illustration of how to mount the camera lens to
the camera body. Be sure to power off the battery before installation.
1. Remove the camera body cap.
2. While holding down the Lens Release Button, rotate the Lens Lock clockwise to unlock it.
3. Remove the lens cap and rear cap.
The Zenmuse X5 currently supports the following lenses, and will support more lenses in the
future.
DJI MFT 15mm f/1.7 ASPH
Panasonic Lumix G Leica DG Summilux 15mm f/1.7 ASPH
Olympus M.Zuiko Digital ED 12mm f/2.0
Olympus M.Zuiko 17mm f/1.8 (Balancing ring will be available on the DJI Store soon)
2
1
Lens Release Button
INSPIRE 1 PRO User Manual
©
2015 DJI. All Rights Reserved.
7