Linking The Remote Controller - dji MATRICE 600 User Manual

Status LED
— Solid Red
— Solid Green
— Solid Purple
— Solid Cyan
Blinking Red
RTH Status LED
— Solid White
Blinking White
Blinking White

Linking the Remote Controller

The remote controller is linked to your aircraft by default. Linking is only required when a new remote
controller is used for the first time. Follow these steps to link a new remote controller:
1. Power on the remote controller and connect it to your mobile device. Then power on the aircraft.
2. Go to the DJI GO app > Camera View >
Controller.
Alarm
chime
chime
2 beeps
2 beeps and chime
1 slow beep repeating
Sound
chime
1 beep repeating
2 beeps repeating
Remote Controller Settings
Remote Controller Calibration
Stick Mode
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
Button Customization
You can customize the C1 and C2 buttons on the back of the RC.
Linking Remote Controller
Remote Controller Status
The remote controller is set as Master but is not
connected to the aircraft.
The remote controller is set as Master and
connected to the aircraft.
The remote controller is set as Slave but is not
connected to the aircraft.
The remote controller is set as Slave and
connected to the aircraft.
Remote controller error. Refer to the DJI GO app
for details.
Aircraft Status
RTH procedure begins.
Sending RTH command to the aircraft.
Aircraft RTH in progress.
> Remote Controller Settings > Linking Remote
C1 Gimbal Pitch/Yaw
C2 Not Defined
MATRICE 600 User Manual
©
2016 DJI All Rights Reserved.
31