dji INSPIRE 1 PRO User Manual page 8

INSPIRE 1 PRO User Manual
4. Align the two Lens Mount Indexes on the camera body and camera lens, and insert the camera lens
into the body of the camera.
5. Rotate the camera lens clockwise until you hear a click.
6. Rotate the Lens Lock counterclockwise to lock it.
7. Mount the Balancing Ring (or a filter) and the Lens Hood.
8. Insert the Micro SD card.
4
To remove the camera lens, power off the battery and then:
1. While holding down the Lens Release Button, rotate the Lens Lock clockwise to unlock it.
2. While holding down the Lens Release Button, rotate the camera lens counterclockwise to detach it.
It is recommended to wrap the dust cover around the lens for aerial applications. The DJI
specified dust cover can be installed on the DJI MFT 15mm f/1.7 ASPH and the Panasonic
Lumix G Leica DG Summilux 15mm f/1.7 ASPH. Purchase an appropriate dust cover for the
Olympus M.Zuiko Digital ED 12mm f/2.0 if necessary.
It is important to tighten the Lens Lock after attaching the camera lens, as this can reduce the
vibrations of the lens when the aircraft is moving in flight. Always loosen the Lens Lock before
attaching and detaching the camera lens.
A filter can be installed in place of the Camera Balancing Ring. Remember to use a filter that
fulfills the weight requirement.
The Lens Hood can only be installed on the DJI MFT 15mm f/1.7 ASPH or Panasonic Lumix G
Leica DG Summilux 15mm f/1.7 ASPH. DO NOT install the Lens Hood on the Olympus M.Zuiko
Digital ED 12mm f/2.0.
Be sure to set the lens to AF mode.
Always hold down the Lens Release Button before rotating the Lens Lock to unlock it.
8
©
2015 DJI. All Rights Reserved.
5
Micro-SD
Balancing Ring (or Filter)
Lens Hood
7
Lens Release Button