The Control For Hdmi Function Does Not Work - Sony STR-DN1060 Parts And Controls

other BLUETOOTH device, or a microwave oven nearby, move it away.
Turn down the volume of the connected BLUETOOTH device.
[282] Troubleshooting
Cannot control the receiver using a "SongPal" device.
It may take some time for the receiver to connect to the network after it is turned on. Try
again later.
The smartphone or tablet device may not be connected to the same network as the
receiver. Connect to the same network and try again.
Also see "Controller devices or applications on the home network cannot connect to the
receiver."
Also refer to the "SongPal" help.
[283] Troubleshooting

The Control for HDMI function does not work.

Check the HDMI connection.
Make sure [Control for HDMI] is set to [On] in the HDMI Settings menu.
Make sure the connected device supports the Control for HDMI function.
Check the Control for HDMI settings on the connected device. Refer to the operating
instructions of the connected device.
If you unplug the HDMI cable or change the connection, repeat the procedures of
"Preparing for "BRAVIA" Sync."
When [Control for HDMI] is set to [Off], "BRAVIA" Sync does not work properly, even if
the device is connected to the HDMI IN jack.
The types and number of devices that can be controlled by the "BRAVIA" Sync feature
are restricted by the HDMI CEC standard as follows:
Recording devices (Blu-ray Disc recorders, DVD recorders, etc.): up to 3 devices
Playback devices (Blu-ray Disc players, DVD players, etc.): up to 3 devices
Tuner-related devices: up to 4 devices (the receiver uses one of them for its GUI operations.)
AV receivers (audio systems): up to 1 device
Make sure your TV is connected to the HDMI OUT A (TV) jack of the receiver (for STR-
DN1060 only).
Make sure the HDMI OUTPUT setting is set to [HDMI A] or [HDMI A + B] (for STR-
DN1060 only).
BLUETOOTH device
"BRAVIA" Sync (Control for HDMI)