Passing Hdmi Signals Through (Standby Through) - Sony STR-DN1060 Parts And Controls

[174] Adjusting Settings

Passing HDMI signals through (Standby Through)

You can output HDMI signals to the TV even when the receiver is in standby mode.
1. Select [Setup] - [HDMI Settings] from the home menu.
2. Select [Standby Through].
3. Select the setting you want.
Auto: The receiver outputs HDMI signals to the TV from the HDMI OUT jack when
the TV is turned on while the receiver is in the standby mode.
Sony recommends this setting if you are using a "BRAVIA" Sync-compatible Sony
TV. This setting saves power in the standby mode compared to the [On] setting.
On: The receiver continuously outputs HDMI signals from the HDMI OUT jack when
in standby mode.
Off: The receiver does not output HDMI signals when in standby mode.
This setting saves power in the standby mode compared to the [On] setting.
Note
When the receiver is in standby mode, the
lights up in amber if [Standby Through] is set to [On] or [Auto].
When [Auto] is selected, it may take a little more time for the image and sound to be
output to the TV than when [On] is selected.
This function does not work for the HDMI OUT B/HDMI ZONE jack. (for STR-DN1060
only)
[175] Adjusting Settings
Setting the HDMI audio signal output of connected
devices (Audio Out)
You can set the HDMI audio signal output of playback devices connected to the receiver via
an HDMI connection.
1. Select [Setup] - [HDMI Settings] from the home menu.
HDMI Settings
HDMI Settings
(on/standby) indicator on the front panel